Your waterW-05
Fluoride in SAWS water
Filed Nov. 11, 2026 · checked against 3 sources · Aquifer to Tap
Fluoride in SAWS water is raised from a natural level of about 0.3 ppm to 0.7 ppm, SAWS says, and 2025 plant readings ranged from under 0.5 to 0.69 ppm against a 4 ppm federal limit.
0.7 ppmSAWS fluoride targetSource: SAWS Fluoride FAQs

SAWS's fluoride FAQ says it "adds enough fluoride to bring the fluoride level up to 0.7 parts per million." The additive is hydrofluorosilicic acid. Water from the Trinity Aquifer is naturally close to that level, so SAWS adds none to it.
When did San Antonio start adding fluoride?
Fluoridation follows a city ordinance approved by voters on Nov. 7, 2000, according to the same FAQ. SAWS began adding fluoride in August 2002.
What the 2026 report shows
The 2026 Water Quality Report lists fluoride among inorganic contaminants monitored at the plants. The 2025 highest level was 0.69 ppm, the range was under 0.5 to 0.69, and both the goal and the legal limit are 4 ppm. The violation column reads "No." The report's likely-source column lists erosion of natural deposits, a "water additive which promotes strong teeth," and discharge from fertilizer and aluminum factories.
| Measure | Value | Source |
|---|---|---|
| Natural level | about 0.3 ppm | SAWS Fluoride FAQs |
| Target after treatment | 0.7 ppm | SAWS Fluoride FAQs |
| 2025 plant range | under 0.5 to 0.69 ppm | 2026 Water Quality Report |
| Federal limit (MCL) | 4 ppm | 2026 Water Quality Report |
| Trinity water | no fluoride added | SAWS Fluoride FAQs |
The report does not say why the range sits partly below the 0.7 target. SAWS blends water from several aquifers and a lake, and the mix by source, including the Trinity wells in northern Bexar County, is tallied in a report on SAWS supplies. Neither SAWS page breaks fluoride down by neighborhood. The undosed Trinity share is small: SAWS's Trinity Aquifer page says its Trinity projects, Texas Water Supply Co., Oliver Ranch and Timberwood Park, supplied about 3,100 acre-feet in 2025, less than 1% of distribution.
Can a home remove it?
SAWS's FAQ names reverse osmosis as a treatment that can take fluoride out. The yearly report's broader point is that point-of-use devices may offer no health benefit when tap water already meets federal standards, which the 2025 fluoride results did. Softeners are a separate topic, aimed at hardness rather than fluoride; the softener question is weighed on its own page.
Fluoride is one line in a long table. The rest of the 2025 results, from lead at the tap to nitrate and radium, are summarized in what the 2026 report says. The same tables appear in the printable 2026 report.
Key facts
- Natural fluoride about 0.3 ppm, raised to 0.7 ppm
- 2025 plant range under 0.5 to 0.69 ppm; limit 4 ppm; no violation
- Voter-approved ordinance Nov. 7, 2000; dosing since August 2002
- Additive: hydrofluorosilicic acid
- Trinity water not dosed; reverse osmosis removes fluoride, SAWS says
Sources
- SAWS — Fluoride FAQs (checked Nov. 11, 2026)
- SAWS — inorganic results at the plants, 2026 report (checked Nov. 11, 2026)
- SAWS — Trinity Aquifer supply page (checked Nov. 11, 2026)